Close

    • And the 2020 Ford Mustang GT500 is over 800 rwhp with E85

      After Lund Racing posted 725 rear wheel horsepower the other day from their GT500 it was only a matter of time before 800 horsepower to the rear wheels was cracked. That amount of time was just a matter of hours.


      The GT500 is already at 803 rear wheel horsepower:


      Quote Originally Posted by Lethal Performance
      Well OK THEN. Lund Racing just popped the 800 mark with their 2020 GT500! The car is equipped with our Lethal Performance race pipes, ID-1050x injectors, removed air box and a custom E85 tune.
      The race to 900+ is on.

      This article was originally published in forum thread: And the 2020 Ford Mustang GT500 is over 800 rwhp with E85 started by Sticky View original post
      Comments 6 Comments
      1. Stevenh's Avatar
        Stevenh -
        Taking it to nearly 8,000 rpm. What a motor.
      1. Sticky's Avatar
        Sticky -
        Click here to enlarge Originally Posted by Stevenh Click here to enlarge
        Taking it to nearly 8,000 rpm. What a motor.
        It keeps making power too... beast.
      1. nbrigdan's Avatar
        nbrigdan -
        1000 WHP coming soon....
        Click here to enlarge
      1. Sticky's Avatar
        Sticky -
        Click here to enlarge Originally Posted by nbrigdan Click here to enlarge
        Beat me to it, I was going to post this.

        Don't see the point when the TVS2650 will easily do 1000+ rwhp
      1. Batman's Avatar
        Batman -
        Click here to enlarge Originally Posted by Sticky Click here to enlarge
        Beat me to it, I was going to post this.

        Don't see the point when the TVS2650 will easily do 1000+ rwhp
        Less heat, and cooler IATs? Just out of curiosity, I would like to see a ProCharger kit on this motor and compare the horsepower and torque curves.
      1. Sticky's Avatar
        Sticky -
        Click here to enlarge Originally Posted by Batman Click here to enlarge
        Less heat, and cooler IATs? Just out of curiosity, I would like to see a ProCharger kit on this motor and compare the horsepower and torque curves.
        A Procharger F1X will make about the same power but with less area under the curve. It will be tough for a centri to beat this blower unless it's massive.

        Considering the boost the needed for the big twin screw to top the TVS2650 it will definitely generate more heat at that point. The TVS2650 will also have an advantage at lower boost levels as far as heat and efficiency.

        The factory blower is just that damn good.