Close

    • Another 700+ whp stock 2020 Ford Shelby GT500 on the Dynojet

      The Dynojet numbers posted a few days ago showing the factory stock 2020 Ford Shelby GT500 Mustang with it 5.2 liter Predator V8 topping 700 horsepower to the rear wheels are no fluke. This one made 705 rwhp in STD correction on a Dynojet.


      Unfortunately no high resolution graph of the STD pull is shown but here it is in SAE correction showing 686 rear wheel horsepower:


      It's an absolute monster. A heavy monster.


      This article was originally published in forum thread: Another 700+ whp stock 2020 Ford Shelby GT500 on the Dynojet started by Sticky View original post
      Comments 4 Comments
      1. SpeedLimit?'s Avatar
        SpeedLimit? -
        @Sticky, Versus a whipple GT350 on the same dyno...
      1. Tony@VargasTurboTech's Avatar
        Tony@VargasTurboTech -
        You need to look at Lund Racnig. He put one on the dyno yesterday. Made 691WHP stock SAE, he put their tune on it, and pulled the air filter in 2 revisions it made 761WHP SAE, and 603WTQ. The platform is no joke...
      1. stosh1's Avatar
        stosh1 -
        Click here to enlarge Originally Posted by Tony@VargasTurboTech Click here to enlarge
        You need to look at Lund Racnig. He put one on the dyno yesterday. Made 691WHP stock SAE, he put their tune on it, and pulled the air filter in 2 revisions it made 761WHP SAE, and 603WTQ. The platform is no joke...
        Beast! A pulley swap, aftermarket exhaust, and a little E85 should be 800+ WHP easy!
      1. Sticky's Avatar
        Sticky -
        Click here to enlarge Originally Posted by stosh1 Click here to enlarge
        Beast! A pulley swap, aftermarket exhaust, and a little E85 should be 800+ WHP easy!
        These will do 1000+ on the factory blower. Insane for sure.